Cisco Implementing Cisco Enterprise Advanced Routing and Services ENARSI Set 2

Router R2 operates in a broadcast, multi-access network. Examine the following output of the show ip ospf neighbor command. Based on the output, with which routers can R2 establish a full adjacency?

RouterA and RouterB are both in OSPF area 2, and RouterA is connected directly to the backbone. Their router IDs are shown below:
RouterA - 165.165.20.15
RouterB - 165.165.10.12
Which commands should be executed on RouterA and RouterB to create a virtual link between the two routers?

Based on the following partial output of the show ip ospf database command, which router roles(s) is Router7 performing? (Choose all that apply.)

Examine the diagram below:
Based on the diagram and the following partial output from Router R2, which networks will be present in the routing table of Router R1?

Refer to the following diagram of an OSPF network. Which of the following routers generate network link advertisements (NLA)? (Choose all that apply.) 885CB989129A5F974833949052CFB2F2

You instructed your assistant to configure redistribution of OSPF routes into EIGRP on Router 9. The routes are not being advertised to EIGRP and you are troubleshooting the problem. The EIGRP process ID is 100 and the OSPF process ID is 20. When you ask your assistant what commands were executed, you are shown the following: What is the problem?

You are the network administrator for a large software organization. You designed the LAN in the organization's main building for connecting the internal LAN to a WAN as shown below:
You have configured EIGRP with the variance parameter set to 3 on all the routers to enable unequal load balancing from the 172.16.1.0 network to the WAN. The delay configured on each of the routers is shown in the LAN diagram, and the K values are set as follows:
K1 = 0
K2 = 0
K3 = 1
K4 = 0
K5 = 0
Which of the following paths are entered into the routing tables as a result of the unequal load balancing configured on the routers? (Choose all that apply.)

OSPF area border routers (ABRs) advertise a default route to stub and totally stubby areas. Which command is the BEST command to configure a cost of 25 for the default route advertised to area 1?

You need to manually assign IPv6 addresses to the interfaces on an IPv6-enabled router. While assigning addresses, you need to ensure that the addresses participate in neighbor discovery and in stateless auto-configuration process on a physical link. Which of the following addresses can be assigned to the interfaces?

You are configuring EIGRP on a spoke router in a hub-and-spoke topology. In an effort to keep the routing table small, the hub router has been configured to send only a default route to the remote routers. What command would you use on the spoke routers to enable them to send only connected and summary routes to the hub router, and prevent the hub router from sending a query to the spoke router when a route is lost elsewhere?