×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which of the following translation mechanisms has the following characteristics?
Translates 1 to 1
Translates IPv6 to IPv6
Translates only the prefix
Is deployed at the network edge
Translates IPv6 to IPv6
Translates only the prefix
Is deployed at the network edge
2.
You have applied the following configuration to Router71, as indicated in the following partial output of the show run command: Which of the following statements is true of this configuration?
3.
You have been asked to troubleshoot the NTP configuration of a router named R70. After executing the show run command, you receive the following partial output of the command that shows the configuration relevant to NTP: Based on this output, which of the following statements is true?
4.
Some of the technicians in your organization use the secure web interface to make some of the configurations changes on the router R68. Today it was reported that a technician could not make a connection to the secure web server. You execute a show run command on R68 and receive the following output: What must the technician do to make the connection to the secure web interface?
5.
You just received the following system message.
885CB989129A5F974833949052CFB2F2
*Mar 1 18:46:11:553 %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
(Switch-2)
With this message in mind, which of the following commands were executed on the device? (Choose all that apply.)
6.
Which of the following statements is NOT true of NPTv6?
7.
You are configuring NAT64 to allow communication between a host running IPv6 and a server running IPv4. The router R1 sits between the host and the server.
The router's Fa0/2/7 interface is connected to the IPv6 host, and the Fa0/2/6 interface is connected to the IPv4 server.
The IPv6 host has an IPv6 address of 2001::a00:1/128 and the IPv4 server is at 10.0.0.1. Below is the relevant configuration on R1:
When the IPv4 server responds to the IPv6 host, what IPv6 address will be in the source address in the packet?
The IPv6 host has an IPv6 address of 2001::a00:1/128 and the IPv4 server is at 10.0.0.1. Below is the relevant configuration on R1:
8.
Your network team is assessing options available to translate IPv6 address to IPv4 addresses. You have focused your attention on the variants of NAT64. One of your requirements is the conservation of IPv4 addresses. Which of the following versions of NAT 64 helps to conserve IPv4 addresses?
9.
Your network team is assessing options available to translate IPv6 address to IPv4 addresses. In which of the following scenarios is stateless NAT64 NOT supported as a solution?
10.
You are implementing IP SLA and would like to use it to measure hop-by-hop response time between a Cisco router and any IP device on the network. Which of the following IP SLA operations would you use for this?