×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
With which of the following control components do UCM media resources interact when UCM needs to locate resources to establish a conference call?
2.
Which of the following is a function of the BAT?
3.
You are troubleshooting voice audio problems on your company's VoIP network. The network carries both data and VoIP traffic. You have obtained the following measurements:
-Jitter: 50 ms
-Packet loss: 1 percent
-End-to-end delay: 150 ms
Which of the following best describes why your company's network is experiencing voice audio problems?
-Jitter: 50 ms
-Packet loss: 1 percent
-End-to-end delay: 150 ms
Which of the following best describes why your company's network is experiencing voice audio problems?
4.
You want an IP phone to use a line prompt instead of an MWI lamp to display information about a new message. Which of the following line appearance fields should you modify in UCM?
5.
Three UCM users are connected on a conference call by using Cisco IP phones. The switch port to which one of the users is connected fails. Which of the following will occur?
6.
Which of the following enables a watcher to monitor the status of a registered dn in real time?
7.
You are manually provisioning an IP phone by using UCM Administration. You want to ensure that UCM provides authentication and integrity for the IP phone. Which of the following fields should you update?
8.
Which of the following QoS features reduces the jitter of voice packets by preventing them from being delayed behind larger data packets in a queue?
9.
Which of the following commands is evaluated first by a voice gateway router for an incoming dial peer?
10.
Which of the following is a function of MTPs?