1.
You are the network engineer at Certkiller .com. Certkiller has its headquarters in New York and a branch office in Delaware. In the branch office, one VoIP dial-peer has been configured to point to headquarters over a low speed serial link. You want to limit the maximum number of concurrent calls to 3. Which command would you use?
2.
What will be the outcome of an incoming VoIP call arriving at CK2 from CK1 , given the following router configurations? CK1 Configuration dial-peer voice 1 pots destination-pattern 1111 port 1/0/0 CK2 Configuration dial-peer voice 1 pots destination-pattern 2222 port 1/0/0 ! dial-peer voice 2 voip destination-pattern 1111 session-targetipv4:172.16.1.1
3.
The following are the original dial peer configurations for routers CK1 and CK2 : CK1 :
dial-peer voice 20 voip destination-pattern 408....... session target ipv4: 192.168.2.254
! CK2 dial-peer voice 21 ports destination-pattern 4085554321 port 1/0/1
!
Which phones can call to the other?
4.
When a call is placed, it is routed toward the destination. Which call legs are created on that router for the call?
5.
Which of the following parameter is checked first when matching inbound dial peers?
6.
What is used to translate called (DNIS) and calling automatic number identification (ANI) numbers before routing the call?
7.
What could happen if the playout delay buffer size is configured too large?
8.
You are the network engineer at Certkiller .com. You have configured dial peers in a hunt group for a Support team that answers when the number 5952215 is dialled. The Support team consists of one senior agent and three junior agents. You want the senior agent to receive the incoming call first. Which dial peer should you configure to point to the senior agent?
9.
With Cisco CallManager Release 3.0, the term "route point" is replaced with which term from the list below?
10.
Which of the following statements is correct when discussing how the Cisco CallManager works with IP Phone registration? (Choose all that apply.)