Cisco Conducting Cisco Unified Wireless Site Survey

1.

How should the transmit power on an access point and client each be set during a site survey?

at 30mW matched to the antenna gain differing by at least 20 dBi matched to each other

2.

What is a site survey best practice for location-based services?

20 percent cell overlap four access points detecting a client at -76 dBm or better 10 percent cell overlap three access points detecting a client at -75 dBm or better

3.

Which statement about active and passive surveys is incorrect?

Active mode does not require the client to be specifically confgured Passive mode can survey more than one access point at a time Active mode yields signal-quality information such as packet retries and lost packets Active mode requires more time to survey but yields more information results than passive mode does

4.

Which statement regarding the site-survey process is correct?

In a multifloor building, the access point layout from the survey of one floor can be directly applied to the remaining floors Access points can be installed in the same place on every floor, without worrying about co-channelinterference You can survey with a Cisco AIR-ANT5959 in a plenum environment Identify all hazardous and restricted areas that might require extra or special survey and installation work

5.

For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey, what are the most appropriate client test settings to use with the AirMagnet site survey tool?

100 mW, 24 Mb/s 100 mW, 18 Mb/s 25 mW, 18 Mb/s 3.2 mW, 54 Mb/s

6.

Which can NOT be selected for supported services in Cisco WCS Planning Tool?

data/coverage location with Monitor Mode access points demand high density

7.

Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg Pulse Duration parameter?

Bluetooth frequency hopping microwave oven 802.11b client card 802.11b access point

8.

Which two Cisco antennas provide better isolation from RF sources that might be located behind the antennas?

AIR-ANT3213 AIR-ANT2465P-R AIR-ANT1949 AIR-ANT5160V-R

9.

Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at the predetermined data rate that is needed to support the VoWLAN device and call capacity requirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and 7925G?

-65 dBm -67 dBm -69 dBm -70 dBm

10.

Which antenna generally has the narrowest first Fresnel zone in both the horizontal and vertical planes?

omnidirectional patch Yagi sector parabolic dish

Cisco Conducting Cisco Unified Wireless Site Survey

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco Conducting Cisco Unified Wireless Site Survey

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner