Cisco Conducting Cisco Unified Wireless Site Survey Set 1

To provide efficient roaming between the cells, which percent of cell overlap is recommended for 2.4 GHz and 5 GHz access points?

What is the minimum recommended access point overlap for voice roaming?

By how much is a signal's strength reduced when the signal passes through an object that introduces 3 dB of attenuation?

When using a lightning arrestor, connect which type of ground wire to a good earth ground?

The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, when using a long Ethernet cable, the device can draw up to how much additional wattage?

When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in a multifloor building with a WLAN that operates at an 11 MB/s data rate, how many decibels referenced to 1 milliwatt of same-channel separation are recommended between floors?

When planning for VoWLAN capacity during a site survey, how many simultaneous calls can be estimated per 5 GHz channel?

In an outdoor bridge link, what is calculated by using this formula: transmitter power + antenna gain - insertion OR cable loss?

When surveying for VoWLAN, which power level should you base the access point coverage design on?

What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent on channel 36, from a source outside of the site?