Cisco Composite Set 2

How does 802.1q trunking keep track of multiple VLAN's?

Which protocol allows for the automatic selection and simultaneous use of multiple available gateways as well as automatic failover between those gateways?

The 192.168.0.0 network is not being propagated throughout the network. Observe the BGP configuration commands from the advertising router. What is the reason the 192.168.0.0 route is not being advertised?
router bgp 65111
neighbor 172.16.1.1 remote-as 65111
neighbor 172.16.2.1 remote-as 65112
network 192.168.0.0
network 10.0.0.0
!
ip route 192.168.0.0 255.255.0.0 null0

Which statement best describes autoconfiguration for IPv6?

You are using multiple routing protocols in different Autonomous Systems (AS). You need to redistribute between the systems. You are using two-way redistribution. Which action should help you avoid routing loop issues?

When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA? (Choose two.)

A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table on RouterA. The following information is available from RouterA: configuration:

Observe the diagram. RTC is the hub router and RTA and RTB are the spokes. There are no virtual circuits between the spoke locations. What is needed to successfully route traffic to the 11.11.11.0/24 network from RTA?

An administrator is redistributing OSPF into RIP. RIP is routing the 128.103.36.0/24 network. OSPF is routing the 128.103.35.32/28 network. Users in the RIP domain cannot reach devices in the OSPF domain. Which two tasks must be done to enable RIP to advertise the routes learned from OSPF into the RIP domain? (Choose two.)