×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What Cisco IOS command produced the following as a part of its output?
Port Security: Enabled
Port status: SecureUp
Violation mode: Shutdown
Maximum MAC Addresses: 2
Total MAC Addresses: 2
Configured MAC Addresses: 2
Aging Time: 30 mins
Aging Type: Inactivity
SecureStatic address aging: Enabled
Security Violation count: 0
Port Security: Enabled
Port status: SecureUp
Violation mode: Shutdown
Maximum MAC Addresses: 2
Total MAC Addresses: 2
Configured MAC Addresses: 2
Aging Time: 30 mins
Aging Type: Inactivity
SecureStatic address aging: Enabled
Security Violation count: 0
2.
Which WAN switching technology is used with ISDN?
3.
Which of the following are NOT valid IPv6 addresses? (Choose all that apply.)
4.
The conference room has a switch port available for use by the presenter during classes. You would like to prevent that port from hosting a hub or switch.
Which of the following commands could be used to prevent that port from hosting a hub or switch?
Which of the following commands could be used to prevent that port from hosting a hub or switch?
5.
Which statement is supported by the following output?
router# show ip protocols
Routing Protocol is "eigrp 3"
Sending updates every 90 seconds, next due in 24 seconds
<>
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 3
Automatic network summarization is not in effect
Maximum path: 4
Routing for Networks:
172.160.72.0
192.168.14.0
<
Routing Protocol is "eigrp 3"
Sending updates every 90 seconds, next due in 24 seconds
<
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 3
Automatic network summarization is not in effect
Maximum path: 4
Routing for Networks:
172.160.72.0
192.168.14.0
<
6.
What command produced the preceding output?
What command produced the preceding output?
7.
You have two routers in your OSPF area 0. Router 1 is connected to Router 2 via its Serial 1 interface, and to your ISP via the Serial 0 interface. Router 1 is an ASBR.
After your assistant configures a default route on Router 1, you discover that whenever either router receives packets destined for networks that are not in the routing tables, it causes traffic loops between the two routers. To troubleshoot, you execute the show run command on Router 1. Part of the output is shown below:
After your assistant configures a default route on Router 1, you discover that whenever either router receives packets destined for networks that are not in the routing tables, it causes traffic loops between the two routers. To troubleshoot, you execute the show run command on Router 1. Part of the output is shown below:
8.
Which type of switching process requires a switch to wait for the entire frame to be received before forwarding it to a destination port?
9.
Which type of Dynamic Host Configuration Protocol (DHCP) transmission is used by a host to forward a DHCPDISCOVER packet to locate a DHCP server on the network?
10.
You need to cable the network shown below.
Which of the following is the correct cable for each numbered link?
Which of the following is the correct cable for each numbered link?