×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Refer to the components below. Which data center design layer contains these components?
- Cisco UCS 6100 Fabric Interconnect
- Cisco Nexus 1000V
- Cisco UCS 5100 Blade Chassis
- Cisco UCS 6100 Fabric Interconnect
- Cisco Nexus 1000V
- Cisco UCS 5100 Blade Chassis
2.
Cisco Nexus 5000 Series Switches are best positioned at which layer?
3.
Which component of the Cisco Nexus 7010 architecture provides out-of-band management, an always-on microprocessor for disaster recovery, and remote restart capabilities?
4.
On a 32-port 10 Gigabit Ethernet module, each set of four ports can handle 10 Gb/s of bandwidth. What can you use the rate-mode parameter for?
5.
On a Cisco Nexus 7000, a CoPP can be applied separately to each VDC.
6.
The persistent storage service (PSS) is used by which function?
7.
A Cisco Nexus 7000 switch is used with the VRF feature to provide separation between the inside and outside interfaces of a transparent firewall. The VRF RED is used for an untrusted network of the virtual data center, and it is connected to the outside interface of the firewall. The VRF GREEN is used as a trusted network of the virtual data center and is connected to the inside interface of the firewall. Subnet 10.10.10.0/20 is used to communicate between two VRFs across the transparent firewall. The firewall is configured correctly. The network administrator configured the VRFs and IP addressing correctly, but you are still unable to communicate across the firewall. What is a likely cause of the problem?
8.
What does the previously active supervisor do when "system switchover" is issued?
9.
Which tasks can be performed only in the default VDC?
10.
Which option describes what takes place when a "storage" VDC is created on Nexus 7000?