×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which WAN switching technology is used by Asynchronous Transfer Mode (ATM)?
2.
You are configuring a serial link between a Cisco router and a router produced by another vendor.
What would be the advantages of using Point to Point Protocol (PPP) over High Level Data Link Control (HDLC) in this scenario?
What would be the advantages of using Point to Point Protocol (PPP) over High Level Data Link Control (HDLC) in this scenario?
3.
You are attempting to add an IP address to an interface on a router with which you are unfamiliar. You type the following command and receive the following error:
Router78(config)#interfce Serial0
^
%invalid input detected at '^' marker.
Which of the following could be a reason for receiving this message?
^
%invalid input detected at '^' marker.
Which of the following could be a reason for receiving this message?
4.
What is the default sequence in which a router searches for the Internetwork Operating System (IOS) image upon power on?
5.
Which type of IP address is a registered IP address assigned by the Internet Service Provider (ISP), and represents one or more inside local IP addresses externally?
6.
You are the switch administrator for InterConn. The network is physically wired as shown in the diagram. You are planning the configuration of STP. The majority of
network traffic runs between the hosts and servers within each VLAN.
You would like to designate the root bridges for VLANS 10 and 20. Which switches should you designate as the root bridges?
network traffic runs between the hosts and servers within each VLAN.
You would like to designate the root bridges for VLANS 10 and 20. Which switches should you designate as the root bridges?
7.
Which statement best describes a converged network?
8.
What is the purpose of frame tagging in Virtual LAN (VLAN) configurations?
9.
The output of the show ip route command is given:
Gateway of last resort is 10.119.254.240 to network 10.140.0.0
O 172.16.0.0 [110/5] via 10.19.24.6, 0:01:00, Ethernet2
B 172.17.12.0 [200/128] via 10.19.24.24, 0:02:22, Ethernet2
O 172.71.13.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
O 10.13.0.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
What does the value 110 in the output represent?
Router# show ip route
Gateway of last resort is 10.119.254.240 to network 10.140.0.0
O 172.16.0.0 [110/5] via 10.19.24.6, 0:01:00, Ethernet2
B 172.17.12.0 [200/128] via 10.19.24.24, 0:02:22, Ethernet2
O 172.71.13.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
O 10.13.0.0 [110/5] via 10.19.24.6, 0:00:59, Ethernet2
What does the value 110 in the output represent?
10.
Which set of Cisco Internetwork Operating System (IOS) commands is used on Cisco routers to set a password for Telnet lines?