Cisco Certified Network Associate CCNA Set 5

You wish to configure Secure Shell (SSH) support on your router so that incoming VTY connections are secure. Which of the following commands must be configured? (Choose all that apply.)

Which Cisco Internetwork Operating System (IOS) command is used to assign a router a name for identification?

Which command is used to disable Cisco Discovery Protocol (CDP) on a Cisco router?

You are the network administrator for your company and have configured Cisco Discovery Protocol (CDP) in your network. You recently noticed that when devices send large numbers of CDP neighbor announcements, some devices are crashing. You decide to disable CDP on the router.
Which command should you use to achieve the objective?

You instructed your assistant to add a new router to the network. The routers in your network run OSPF. The existing router, OldRouter, is configured as follows:
router ospf 1
network 192.168.5.0 0.0.0.255 area 0
network 192.168.10.0 0.0.0.255 area 0
The OldRouter interface that connects to NewRouter is 192.168.5.3/24. Your assistant shows you the configuration that will be implemented:

Which Wide Area Network (WAN) switching technology is used by Asynchronous Transfer Mode (ATM)?

You are configuring the link between a Cisco 2950 series switch and a Cisco 2611 router. You have physically connected the router's Ethernet port to the switch
using a straight-through cable. The switch has not been configured, except for a hostname. The router's hostname has also been configured, and the Ethernet port
has been enabled. However, you forgot to assign an IP address to the Ethernet port.
You issue the show cdp neighbors command and get the following output:
If you did not configure IP addresses, how is this information being passed between the two devices?

Which of the following is a Point-to-Point Protocol (PPP) authentication protocol that supports sending of hashed values instead of sending passwords in clear text?

With which type of service is bandwidth and latency the biggest consideration?

With respect to the network shown below, which of the following statements are true when R2 sends a packet to the 192.168.6.0/24 network? (Choose all that apply.) 885CB989129A5F974833949052CFB2F2