×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
You know that Router2 is configured for RIP. Which Cisco Internetwork Operating System (IOS) command is used to view the current state of all active routing protocols?
2.
You apply the following commands to a router named R2:
R2(config)# interface Tunnel1
R2(config-if)# ip address 172.16.1.2 255.255.255.0
R2(config-if)# ip mtu 1400
R2(config-if)# ip tcp adjust-mss 1360
R2(config-if)# tunnel source 2.2.2.2
R2(config-if)# tunnel destination 1.1.1.1
Which statement is NOT true with regard to this configuration?
R2(config-if)# ip address 172.16.1.2 255.255.255.0
R2(config-if)# ip mtu 1400
R2(config-if)# ip tcp adjust-mss 1360
R2(config-if)# tunnel source 2.2.2.2
R2(config-if)# tunnel destination 1.1.1.1
Which statement is NOT true with regard to this configuration?
3.
Which command would be used to list the timers, version of spanning tree and the bridge ID of the local and designated switch for a specific VLAN on a Cisco Catalyst 2950 series switch?
4.
File Transfer Protocol (FTP) and Simple Mail Transfer Protocol (SMTP) work at which layer in the Open Systems Interconnection (OSI) model?
5.
A router is running several routing protocols, and as a result has learned three routes to the 192.168.5.0 network. Below are the details about the three learned
routes:
Based on this information, which route will be placed in the routing table?
routes:
Based on this information, which route will be placed in the routing table?
6.
How will SwitchB handle the frame it just received?
7.
Which of the following features is used with the ip nat inside command to translate multiple devices in the internal network to the single address in the IP address pool?
8.
Which feature enables a host to obtain an IP address from a DHCP server on another subnet?
9.
Which of the following commands configures an SNMP host to authenticate a user by username and send clear text notifications, the receipt of which will be acknowledged by the receiver?
10.
What configuration is needed to span a user defined Virtual LAN (VLAN) between two or more switches?