×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What command makes it possible to run MPLS/LDP in secure mode between P and PE?
2.
What QoS mechanism is used and supported with EoMPLS?
3.
On a 3550 switch, private vlan edge is known as:
4.
A network administrator is using debug commands to check the performance of a network. What steps can the
administrator take to ensure that the "debug" will not require too much CPU, or at least that she will not have to
reboot the router to disable debug? (multiple answer)
5.
Which are supported ways of transporting ATM over MPLS?
6.
IEEE 802.1D describes a method to prevent the disconnection of a single end station from disruption Spanning Tree. What does the method describe?
7.
The purpose of Administrative Distance, as used by Cisco routers, is:
8.
What is the protocol that On-Demand Routing relies on?
9.
What protocol is used to exchange control information between active and standby supervisors in order to support redundancy?
10.
When executing the following show mpls l2transport vc detail command, you notice the link does not come up.
Choose the most likely cause.
PE#sho mpls l2transport vc detail
Local interface: Et0/0 up, line protocol up, Ethernet up
Destination address: 172.168.1.102, VC ID: 100, VC status: down Preferred path: not configured
Default path: active
Tunnel label: 16, next hop point2point
Output interface: Se5/0, imposed label stack {16 16}
Create time: 00:18:10, last status
change time: 00:03:51
Signaling protocol: LDP, peer 172.168.1.102:0 up
MPLS VC labels: local 16, remote 16
Group ID: local 0, remote 0
MTU: local 1500, remote unknown
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, send 78
Choose the most likely cause.
PE#sho mpls l2transport vc detail
Local interface: Et0/0 up, line protocol up, Ethernet up
Destination address: 172.168.1.102, VC ID: 100, VC status: down Preferred path: not configured
Default path: active
Tunnel label: 16, next hop point2point
Output interface: Se5/0, imposed label stack {16 16}
Create time: 00:18:10, last status
change time: 00:03:51
Signaling protocol: LDP, peer 172.168.1.102:0 up
MPLS VC labels: local 16, remote 16
Group ID: local 0, remote 0
MTU: local 1500, remote unknown
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, send 78