Cisco CCIE Written Metro Ethernet Set 1

Estimating the MTU for EoMPLS Packets Edge MTU of 1500, Transport header, AToM header present, MPLS label, and stack MPLS Label, calculate the core MTU requirements to handle EoMPLS port mode packets.

What protocol is not disabled by the 'no service tcp-small-servers' command?

Which are components of VPLS?

What is NOT true regarding PW QoS?

What QoS mechanism is used and supported with EoMPLS?

Within OSPF, what functionality best defines the use of a 'stub' area?

An incoming frame is received by a transparent bridge. If the destination address of the frame is not present in the database, the bridge will:

When using IS-IS for IP routing, Dual IS-IS defined by RFC 1195, what is true? (multiple answer)

Traceroute does not work on Host A (a Unix workstation) to the Internet. Currently, there is an inbound access- list applied to the serial interface on Router 1 that says "access-list 101 permit tcp any any". What access-list entry may need to be added in order to get traceroute to work?

Observing the output below from the PE router, select what path EoMPLS will take before exiting a router:
PE#show mpls l2transport vc 100 detail Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up
Destination address: 172.0.0.3, VC ID: 100, VC status: up Preferred path:
Tunnel1, active Default path: disabled Tunnel label: 3, next hop point2point Output interface: Tu1, imposed label stack {27 20} Create time: 00:07:11, last status change time: 00:07:11 Signaling protocol:
LDP, peer 172.0.0.3:0 up MPLS VC labels: local 16, remote 20 Group ID: local 0, remote 0 MTU: local 1500, remote 1500 Remote interface description: Sequencing: receive disabled, send disabled