Cisco CCIE Wireless Written Set 4

A "system initialization" is used to perform what function on the MDS switch?

You are connecting a new switch to an existing two switch Fabric with domain IDs of 1 and 2. The new switch has a domain ID of 1. The principal switch of the existing fabric has a principal switch priority of 10 and is
Domain 1. The new switch has a principal switch priority of 1 configured and has the lowest switch WWN of all 3 switches.
What switch will be the principal switch after the new switch is added?

FICON-enabled nodes send a Fabric Login (FLOGI) extended link service command to the well known Fibre Channel Service address of

Before you can successfully enable the Call Home feature, which of the following must be true?

What method of load balancing is flow based?

From the configuration below, whatVSAN(s) would iSCSI host 10.1.1.8 appear? iscsi interface vsan_membership vsan database vsan 200 interface iscsi3/1 iscsi initiator ip_address 10.1.1.8 vsan 100 vsan
101 interface iscsi3/1 switchport proxy_initiator nWWN 11 :11 :11 :11 :11 :11 :11 :00 pWWN 11 :11 :11 :11 :11 :11 :11 :11 no shutdown

Log messages are not showing up in fabric manager. What is the most likely the cause?

Which are requirements to configure FCIP on a MDS FC Switch?

The purpose of the SW_ILS ELP frame is to:

Two switches are merging together. During principal switch selection, Switch A sends a frame indicating it has an empty domain ID list. Switch B sends a frame indicating that there are previously allocated domain IDs.
Switch A has a lower priority value and a lower WWN. What should occur next?