Cisco CCIE Wireless Written Set 3

1.

MDS authentication method configuration:
tacacs+ enable tacacs-server host 10.1.1.1
aaa authentication login default group tgroup
aaa group server tacacs+ tgroup
server10.1.1.1
User "admin" is configured on the tacacs+ server with password "admin123", and MDS is configured with CLl user "admin" and password "admin" locally - both as group "network-admin".
What happens when the user logs into MDS with the username "admin" password "admin"?

Authentication failed with tacacs+ server, but granted access with role "network-operator" Authentication failed with tacacs+ server, access denied Authentication succeed with local database, granted with role "network-admin" Authentication succeed with local database, granted with role "network-operator" None above

2.

What statement is NOT correct for FCIP compression?

FCIP compression uses LZS compression algorithm FCIP compression is dependent on the type of data compressed By default FCIP compression is disabled High-throughput and high-comp-ratio mode may be configured simultaneously FCIP compression has to be configured under FCIP interface

3.

FC protocol is a layered protocol consisting of several layers Identify these layers in proper order of FC-O to FC-4:

Media Layer, Encode/Decode Layer, Framing & Control Layer, Common Services Layer, Upper Level
Protocol Layer Encode/Decode Layer, Media Layer, Framing & Control Layer, Common Services Layer, Upper LevelProtocol Layer Framing & Control Layer, Encode/Decode Layer, Media Layer, Common Services Layer, Upper LevelProtocol Layer Upper Level Protocol Layer, Common Services Layer, Framing & Control Layer, Encode/Decode Layer,Media Layer Media Layer, Framing & Control Layer, Encode/Decode Layer, Common Services Layer, Upper LevelProtocol Layer

4.

In a long distance link of 100 KM, which is true of the desired number of BB credits?

More BB credits would cause excessive delay in handling the larger number of packets The fewer the BB credits there are, the less likely we are to have a packet lost in the network With fewer BB credits, the transmission pipe will not be full and this will lead to other applications gettingbandwidth should they need it The Fe standard defines the number of credits on a long distance link None of the above answers are correct

5.

What primitive is used on an arbitrated loop when a device is attempting to connect?

NOS ARB LIP IDLE Online

6.

The IPS iSCSI gateway has two forwarding modes An advantage of using "pass-thru" mode is?

IPS converts and forwards full iSCSI PDU to the Target IPS creates only one initiator to reduce configuration IPS converts and forwards one frame at a time which keeps latency low IPS uses fixed MSS for constant payload to reduce latency

7.

What statement is true?

Class of Service 3 frames require an ACK1 response R_RDY is the correct way to acknowledge a Class of Service 1 frame Class of Service 2 frames are acknowledged by an ACK response Class of Service 1 frames are acknowledged only when requested by the sender Class of Service 1 and 2 reserve 100% of the available bandwidth

8.

On a 9506, FICON has been enabled on VSAN 2 using a Domain id of 0x05. All of the fibre channel ports in the switch have been placed in this VSAN.
The switch is using the default value for fcid-last-byte. The following command is issued on the switch: ficon swap portnumber 10 11
What FCID will be used to access the storage connected to interface fc 1/11?

0x050900 0x050bOO 0x051000 0x051100 0x0510ff

9.

A vty terminal type can be changed to vt100 by what method or command?

From EXEC level enter "terminal terminal-type vt100 From configuration mode enter "terminal vty 0-4 type vt100" From configuration mode enter "line 0-4 type vt100" From EXEC level enter "line mode terminal-type vt100" None _ the vty terminal type cannot be changed

10.

A TL port is needed to accomplish what?

Create a trunk loop between 2 ports Permit larger frames to be sent on that port Let public devices be visible to the fabric Let public devices remain invisible to the fabric Let private devices be visible to the fabric

Cisco CCIE Wireless Written Set 3

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco CCIE Wireless Written Set 3

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner