Cisco CCIE SP Content Networking Recertification Set 3

1.

A Fast Ethernet connection supporting multiple VLANs is referred to as:

A circuit group An emulated LAN (LANE) A trunk All of the above

2.

What are the communication ports used by the GSS for inter-GSS communication?

UDP 2001-2009 and UDP 3001-3009 UDP 2001-2009 and TCP 2001-2009 UDP 3001-3009 and TCP 3001-3009 UDP 3001-3009 and TCP 2001-2009 TCP 2001-2009 and TCP 3001-3009

3.

After OSPF is defined on a broadcast medium, the network administrator now wants a specific router to act as the Designated Router (DR) for a particular segment. What must the administrator do to ensure this always occurs?

Ensure the required router is the first to load, so it can assume the role of the Designated Router Configure the required router with the highest IP address on this segment Configure ip ospf priority on the interface, using a lower value than any other router on this segment Configure ip ospf priority on the interface, using a higher value than any other router on this segment

4.

How is it possible to allow servers to be directly accessed when they are being load balanced through the CSM in routed mode?

Create a vserver with a virtual IP address of 0.0.0.0 and have a static route point to the CSM's server side
VLAN for traffic
destined to the servers. Include predictor forward and no nat client in the server farm. Create a vserver with a virtual IP address of the server and have a static route point to the CSM's client sideVLAN for traffic
destined to the servers. Include predictor forward and no nat server in the server farm. Create a vserver with a virtual IP address of 0.0.0.0 and have a static route point to the CSM's server sideVLAN for traffic
destined to the servers. Include predictor forward and nat client in the server farm. Create a vserver with a virtual IP address of 0.0.0.0 and have a static route point to the CSM's client sideVLAN for traffic destined
to the servers. Include predictor forward and nat client in the server farm.

5.

Within a Content Delivery Network there are 3 ways to get a client to the closest Content Engine for delivery of Content. One way is using Simplified Hybrid Routing. The other 2 ways are:

Using WCCP on a router for transparent redirection or setting the proxy settings in a browser point to the
closest Content Engine. Using WCCP on a router for transparent redirection or using DNS to resolve to the correct Content Engine. Using DNS to direct the request to a content router and using a HTTP redirect to have the client go directlyto the Content Engine. Using a Coverage Zone file on the client and then using an HTTP redirect to have the client redirect to theclosest Content Engine. Setting up proxy settings in a browser pointing to the closest CE or using DNS to provide the IP address ofthe closest CE.

6.

What ISDN timer is started after Q.931 SETUP msg is sent?

T301 T303 T302 T310 T305

7.

What statement regarding Network Qualifier Lists (NQL) is most correct?

It is used to define a list of IP addresses and networks to simplify and enhance the implementation of ACLs. It is used to define a list of IP addresses to simplify and enhance the implementation of advanced balancedsticky source IP. It is used to define a list of IP addresses of hosts allowed SNMP access to a Content Smart Switch. It is used to define a list of IP addresses of FTP servers.

8.

What is Forwarding Equivalence Class assignment NOT likely to be based upon?

Fragment offset Destination address Application protocol Class of service

9.

For communications systems what describes the over-all health of the system?

Bit-Error-Rate (BER) Synchronous Optical NETwork (SONET) Optical Signal to Noise Ratio (OSNR) None of the above

10.

In MPLS what is an LSP?

Label Selection Pair Label Switched Path Lightweight Signaling Protocol Large Sampling Path

Cisco CCIE SP Content Networking Recertification Set 3

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco CCIE SP Content Networking Recertification Set 3

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner