Cisco CCIE SP Content Networking Recertification Set 2

1.

What is the WCCP Service Group number for Reverse Proxy?

80 90 82 99

2.

To eliminate the need for adjacent routers on broadcast networks to form n(n-1)/2 adjacencies, IS-IS defines a pseudonode or Designated Intermediate System, DIS. All router on the broadcast medium form an adjacency with the DIS. The Backup DIS is called:

Redundant DIS BDR There is no concept of a backup DIS in IS-IS Designated Redundant System

3.

In Frame Relay, the FECN bit is set by:

The Frame Relay network, to inform the DTE receiving the frame that congestion was experienced in the
path from source to
destination The Frame Relay network, in frames traveling in the opposite direction from those frames that encounteredcongestion The receiving DTE, to inform the Frame Relay network that it is overloaded and that the switch shouldthrottle back The sending DTE, to inform the Frame Relay network that it is overloaded and that the switch should throttleback Any device that uses an extended DLCI address

4.

Within OSPF, what functionality best defines the use of a 'stub' area?

It appears only on remote areas to provide connectivity to the OSPF backbone. It is used to inject the default route for OSPF. It uses the no-summary keyword to explicitly block external routes, defines the non-transit area, and usesthe default route to
reach external networks. It is a non-transit area that does not allow flooding of external networks and uses the default route to reachexternal networks.

5.

The website www. Certkiller .com is having problems. The PC you are troubleshooting from does not have a web browser or sniffer software installed. Which method is the next best way to verify that the website will return the web page with content:

tracert www. Certkiller .com 80 ping www. Certkiller .com telnet www. Certkiller .com 80GET / HTTP/1.0 telnet www. Certkiller .com 80 telnet www. Certkiller .com 80HEAD / HTTP/1.0

6.

What is a possible way to avoid assymetric traffic flow when using the CSM for server load balancing and the CSM's server side VLAN has an IP address configured on the MSFC?

In the server farm use the client nat command with a nat pool. Use policy based routing to force traffic through the CSM's client side VLAN. Use policy based routing to force traffic through the CSM's server side VLAN. Set the server's default gateway to the CSM's client side IP address.

7.

BGP can implement a policy of 'Route Dampening' to control route instability. What statement about route dampening is NOT correct?

A numeric penalty is applied to a route each time it flaps. The penalty is exponentially decayed according to parameters, such as half-life-time. The history of unstable routes is forwarded back to the sender to control future updates. The route is eventually suppressed based on a configurable 'suppress limit'.

8.

It is desired to have the CSM match on the following URLs: /index.html /Index.html abc/index.html abc/ Index.html What should be used?

map TESTMAP url
match protocol http url */?ndex.html map TESTMAP urlmatch protocol http url */i*Index.html map TESTMAP urlmatch protocol http url *ndex.html map TESTMAP urlmatch protocol http url "*/ndex.html

9.

What is the best definition of the use of "Area 0" in OSPF?

Area 0 is used for administrative reasons, and is restricted from user definition. Area 0 is defined as the backbone, designed to be at the center of all routing updates, and controls thedissemination of updates
between areas. Area 0 is used to authenticate messages received from other routers in the same area. Area 0 is used for forwarding all routing updates received within the same Autonomous System from directlyconnected areas
only. Area 0 allows for routing updates to be forwarded between different Autonomous Systems.

10.

The two label distribution protocols that provide support for MPLS traffic engineering are:

RSVP and OSPF CR-LDP and IBGP RSVP and CR-LDP LPS and LDS

Cisco CCIE SP Content Networking Recertification Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco CCIE SP Content Networking Recertification Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner