1.
What statement regarding Service Selection Gateway is INCORRECT?
2.
Virtual path identifier (VPI) and virtual channel identifier (VCI) values on the NRP-2 must share ___bits. By default, VPI values are limited to ___ bits (0-15), and VCI values are limited to ___ bits (0-1023). A Network
Administrator can change the VPI and VCI ranges, but together the VPI and VCI values cannot exceed ___ bits. Which numbers below, correctly fill in the blanks?
3.
An architecture that utilizes PPPoA deals with IP address allocation by what type of negotiation?
4.
According to the diagram, a PPPoE session is initiated by the user from the PC using the username johndoe@isp1.com. This PPPoE session ultimately terminates on the ISP router, using
domain based tunneling on 6400. What is the correct sequence of events which occur during user authentication?
5.
In this network, Host A is trying to reach Host D. There is no routing protocol running, but Router B and C have the following static routes configured:Router B: ip route 10.1.3.0 255.255.255.0 ethernet 1Router C: ip route
10.1.1.0 255.255.255.0 ethernet 1
6.
Given the four networks listed, what valid summary address (below) contains the longest prefix?
7.
Using the shown debugging excerpt, what option best describes the problem?
8.
What Q.931 message cannot be received in response to sending a Q.931 SETUP message?
9.
What signaling protocol does Cisco use to provide support for MPLS traffic engineering?
10.
What is NOT a reason to deploy MPLS?