Cisco CCIE Service Provider Cable Recertification Set 1

What is NOT an ATM class of service?

What describes a technique, used to encapsulate voice (NOT data) over ATM?

What is the purpose of rate decoupling for ATM transmission?

The ATM reference model is composed of which ATM layers? (multiple answer)

What mechanism should be employed to limit the "transmit rate" from Router A to Router C?

Router A has a 512K-access port into the frame relay cloud. Router B has 128K-access port into the frame relay cloud. The two routers are connected with symmetrical PVCs that are configured for 64K committed information rate (CIR). What Frame Relay Traffic Shaping map-class sub-command should be entered on
Router A to prevent workstation A from overrunning the access port on Router B?

The CLI command "show cable hop":(multiple answer)

In this diagram, Host G is attempting to send a packet to Host A through Router E. All routers are running
EIGRP, and Router E has installed the following route in its routing table:1.1.0/24 via router FWhat will occur when Router E receives packets from Host G that are destined for Host A?

Routers E and F are running HSRP (Hot Standby Router Protocol). Router E has a higher priority, and both routers have standby preempt configured. Since Router E is normally the active router, what IP address should
Host G use for its default gateway?

Which can occur if cables other than those recommended for connecting the uBR7200 series cable modem line card(s) to the HFC network are used? (multiple answer)