Cisco CCIE Routing and Switching Written

You issue the show ip nhrp detail command on RouterA and receive the following output:
Which of the following flags indicates that the entry cannot be overwritten by a different NBMA entry with the same IP address? (Select the best answer.)

Which of the following commands should you issue to increase the number of protocols that NBAR can classify and inspect? (Select the best answer.)

You administer the OSPF network shown above. The cost values are displayed next to each link.
RA receives packets destined for the 172.20.0.0/24 network.
How many paths will RA use to send the packets? (Select the best answer.)

Which of the following IPv6 addresses is used as the source address in OSPFv3 packets? (Select the best answer.)

Which of the following commands will cause iBGP routes to have the same AD as internal EIGRP routes? (Select 2 choices.)

You issue the show adjacency command on RouterA and receive the following output:
Which of the following is not a step in troubleshooting the incomplete marker in the output? (Select the best answer.)

Which of the following entries in the output of the show ip eigrp topology command indicates that a route is undergoing recomputation? (Select the best answer.)

The MPLS TTL field of a packet is set to 0.
Which of the following statements is accurate? (Select the best answer.)

Which of the following commands should you issue to manually attach a traffic policy to an interface in an NBAR configuration? (Select the best answer.)

Which of the following statements are true regarding the IGMPv3 source filtering feature? (Select 2 choices.)