1.
Which statement about SAN port channels configured on Cisco Nexus 5000 Series Switches is true?
2.
Which capabilities are not supported in DCNM device manager?
3.
If the default VDC is configured to limit resources to a specific module type, what happens when a module that does not match the resource type is installed?
4.
What does the mac packet-classify command do when applied to an interface configuration?
5.
After configuring FabricPath, the following appears in the syslog:
%STP-2-L2GW_BACKBONE_BLOCK: L2 Gateway Backbone port inconsistency blocking port port- channel100 on VLAN0010.
What is the cause of this message?
6.
On the Cisco Nexus 7000 Series Switch, Control Plane Policing is enforced on which component?
7.
2012 Feb 23 23:00:08.676710 pim: [16132] (default-base) Received unauthenticated hello-message from 10.1.1.2 on Ethernet1/18, message discarded
2012 Feb 23 23:00:12.528763 pim: [16132] (default-base) Send Hello with AH on Ethernet1/18 from 10.1.1.1, holdtimE. 105 secs, dr-priority: 1
You are troubleshooting a PIM neighbor adjacency that is not coming up. You issued the command show ip pim neighbor e1/18 and confirmed there is no PIM neighbor on the interface.
What is the problem based on the debug output?
8.
What is the benefit of using Anycast RP via RFC 4610 for IP multicast RP redundancy?
9.
Which statement best describes ACL configuration using configuration session mode on Cisco Nexus switches?
10.
Overlay Transport Virtualization (OTV) uses the Authoritative Edge Device (AED) to perform which tasks?