×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Refer to the command that is shown below. A host that is connected to the NPV switch is not able to see the
storage that is connected to the core switch. What is the most likely reason for this problem?
Switch# show npv status
npiv is enabled
External Interfaces:
====================
InterfacE. fc1/1, VSAN: 1, FCID. 0x000000, State: Other
Number of External Interfaces: 4
storage that is connected to the core switch. What is the most likely reason for this problem?
Switch# show npv status
npiv is enabled
External Interfaces:
====================
InterfacE. fc1/1, VSAN: 1, FCID. 0x000000, State: Other
Number of External Interfaces: 4
2.
Which type of port provides multihop FCoE connections between FCoE capable switches?
3.
In a Cisco Nexus 5000 switch, each system class has an associated IEEE 802.1p CoS value that is assigned by default or configured on the system class. If you enable PFC, the switch sends the no-drop CoS values to the adapter, which then applies PFC to these CoS values.
What is the default CoS value for the FCoE system class?
What is the default CoS value for the FCoE system class?
4.
It is possible to run multiple VEMs per hypervisor host.
5.
Physical switches that are alike maintain a centralized forwarding engine. Cisco Nexus 1000V Series Switches apply the same concept.
6.
The Cisco Nexus 1000V VSM must be in the same Layer 2 network as the VEMs.
7.
How many VSD are supported per VSM?
8.
Which parameter of the Cisco Nexus 1000V is used to identify a VSM and VEM as related to one another?
9.
How many predefined protocol classes exist for class-based weighted fair queuing on Cisco Nexus 1000V?
10.
How many VSM modes are there in a Cisco Nexus 1000V environment?