×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
You are the Cisco Network Designer in P4S. Which of these
are important when determining how many users a NAS can
support?
are important when determining how many users a NAS can
support?
2.
The P4S company has a lot of retail locations currently serviced by a hub-and-spoke Frame Relay network using OSPF as the routing protocol. This firm decides to deploy a high-bandwidth application requiring any-to-
any connectivity. Which one of the following technologies can offer the best bandwidth utilization and greatest scalability to P4S?
any connectivity. Which one of the following technologies can offer the best bandwidth utilization and greatest scalability to P4S?
3.
To ensure voice packets are kept within the Committed Information Rate (CIR) of a Frame Relay link, what should be used in the CPE?
4.
Which item is the primary requirement when deploying OSPF graceful restart on a router?
5.
You are the Cisco Network Designer in P4S. Which layer NAS operating mode are ACL filtering and bandwidth throttling only provided during posture assessment?
6.
A certain service provider provides RFC 2547-based L3VPN service and uses OSPF to carry infrastructure
routes and MP-BGP to carry customer routes. It has also used a full mesh of Cisco MPLS TE tunnels with FRR
for link and node protection. OSPF and BGP have not
been tuned for faster convergence.
In this service provider's network, which three failure types does Cisco MPLS TE FRR address? (Choose
three.)
routes and MP-BGP to carry customer routes. It has also used a full mesh of Cisco MPLS TE tunnels with FRR
for link and node protection. OSPF and BGP have not
been tuned for faster convergence.
In this service provider's network, which three failure types does Cisco MPLS TE FRR address? (Choose
three.)
7.
A virtual storage area network (VSAN) is a collection of ports from a set of connected Fibre Channel switches, that form a virtual fabric. Which technology allows centralized storage services to be shared across different VSANs?
8.
Connecting four routers running IS-IS to a single Ethernet link. Then, a fifth router is connected, the priority of this router is higher than that of the other four.
What will happen?
What will happen?
9.
Which content networking device allows bandwidth configuration settings so that streaming content will not interfere with other network traffic?
10.
Which tool enables a network designer to route traffic according to the source IP address?