×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
A network administrator is trying to add a new router into an established OSPF network.
The networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
The networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
2.
If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?
3.
What is the default administrative distance of the OSPF routing protocol?
4.
What does a Layer 2 switch use to decide where to forward a received frame?
5.
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose
two.)
two.)
6.
On the basis of the IEEE 802.1w standard, which two switch ports can forward traffic?
7.
Given that Host A and Host B are in different networks. When Host A is trying to communicate with Host B, which step will Host A take first?
8.
For which type of connection should a straight-through cable be used?
9.
Which set of commands is recommended to prevent the use of a hub in the access layer?
10.
Which Cisco Catalyst feature automatically disables the port in an operational PortFast upon receipt of a BPDU?