×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
An administrator must assign static IP addresses to the servers in a network. For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address.
Which of the following should be entered into the IP properties box for the sales server?
Which of the following should be entered into the IP properties box for the sales server?
2.
Which subnet mask would be appropriate for a network address range to be subnetted for up to eight LANs, with each LAN containing 5 to 26 hosts?
3.
What is the effect of using the service password-encryption command?
4.
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?
5.
Which statement about access lists that are applied to an interface is true?
6.
Which parameter CM parameters are used to calculate OSPF cost in Cisco routers?
7.
A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router.
How should the network administrator configure the serial interface of the main office router to make the connection?
How should the network administrator configure the serial interface of the main office router to make the connection?
8.
VLAN 3 is not yet configured on your switch. What happens if you set the switchport access vlan 3 command in interface configuration mode?
9.
A network engineer wants to allow a temporary entry for a remote user with a specific username and password so that the user can access the entire network over the Internet. Which ACL can be used?
10.
Which of the following protocols uses both TCP and UDP ports?