×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which two commands can be used to verify a trunk link configuration status on a given Cisco switch? (Choose
two)
two)
2.
You are working in a data center environment and are assigned the address range 10.188.31.0/23.
You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.
Which IP address range meets these requirements?
You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.
Which IP address range meets these requirements?
3.
Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network address?
4.
Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?
5.
Which statement about vlan operation on cisco catalyst switches is true?
6.
A network administrator receives an error message while trying to configure the Ethernet interface of a router with IP address 10.24.24.24/29.
Which statement explains the reason for this issue?
Which statement explains the reason for this issue?
7.
Which command enables RSTP on a switch?
8.
The enable secret command is used to secure access to which CLI mode?
9.
Which address is the IPv6 all-RIP-routers multicast group address that is used by RIPng as the destination address for RIP updates?
10.
Which IPsec security protocol should be used when confidentiality is required?