Cisco Building Scalable Cisco Internetworks (BSCI) Set 5

The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning.
It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560.
Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?

What is an appropriate use of a default route?

A medium-sized company has a Class C IP address. It has two Cisco routers and one non-Cisco router. All three routers are using RIP version 1.
The company network is using the block of 198.133.219.0/24. The company has decided it would be a good idea to split the network into three smaller
subnets and create the option of conserving addresses with VLSM. What is the best course of action if the company wants to have 40 hosts in each of the three subnets?

Select the action that results from executing these commands.
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky

Running both IPv4 and IPv6 on a router simultaneously is known as what?

Identify the four valid IPv6 addresses. (Choose four.)

Refer to the following protocols, which one can create a secure terminal connection to a remote network device?

What is the maximum data rate specified for IEEE 802.11b WLANs?

How does using the service password-encryption command on a router provide additional security?