Cisco BSCI Building Scalable Cisco Internetworks Set 4

Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?

What will occur when an IPv6 enabled router running 6to4 must transmit a packet to a remote destination and the next hop is the address of 2002::/16 ?

According to RFC 2328, what is the stateful order in which an OSPF router transitions to a full adjacency with a neighbor router?

You have been tasked with setting up OSPF on an existing PassGuide router usingIPv6.
Which command enables OSPF for IPv6 on a router?

A router has two paths to reach another network in a different autonomous system. Neither route was generated by the local router and both routes have the same default weight and local preference values. Which
statement is true about how BGP would select the best path?

Based on the need to limit processing and bandwidth utilization due to dynamic routing protocol operation, the following routing requirements have been specified for your network.
- partial and incremental routing updates
- only the devices affected by a topology change perform route recomputation
- route recomputation only occurs for routes that were affected Which dynamic routing protocol should be deployed in your network to best meet these requirements?

According to RFC 2328, what is the stateful order in which an OSPF router transitions to a full adjacency with a neighbor router?

The company and the company network have both been growing rapidly. Multiple adds, moves and changes have been applied to the network. Your boss has asked you to troubleshoot a recent OSPF synchronization
problem that has arisen. There have been synchronization problems at separate locations in the OSPF area 0.
There have been reported link failures during the rapid growth of the company network. You are required to resolve the OSPF problem. OSPF must be able to converge when the network changes.
Examine the following excerpt from the "show ip ospf" command on D1:
Area BACKBONE (0)
Number of interfaces in the this area is 1
Area has no authentication
SPF algorithm last executed 00:00:31.280 ago
SPF algorithm executed 5 times
Area ranges are
Number of LSA 13. Checksum Sum 0x16F0FD
Number of opaque link LSA 0. Checksum Sum 0

The company and the company network have both been growing rapidly. Multiple adds, moves and changes have been applied to the network. Your boss has asked you to troubleshoot a recent OSPF synchronization
problem that has arisen. There have been synchronization problems at separate locations in the OSPF area 0.
There have been reported link failures during the rapid growth of the company network. You are required to resolve the OSPF problem. OSPF must be able to converge when the network changes.
Which configuration command on D1 (with a similar command on D2) will provide an immediate solution to the missing route problem?

The company and the company network have both been growing rapidly. Multiple adds, moves and changes have been applied to the network. Your boss has asked you to troubleshoot a recent OSPF synchronization
problem that has arisen. There have been synchronization problems at separate locations in the OSPF area 0.
There have been reported link failures during the rapid growth of the company network. You are required to resolve the OSPF problem. OSPF must be able to converge when the network changes.
The log of d1 reports the following:
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1,
changed state to down
%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down
%OSPF-5-ADJCHG: Process 1, Nbr 8.187.175.82/32 on FasstEthernet0/1
from FULL to DOWN,
Neighbor Down: Interface down or detached
This event was anticipated due to maintenance; however, it resulted in excessive lost routes. Which route should be the only one removed from the routing tables of the routers?