Cisco BSCI Building Scalable Cisco Internetworks Set 1

Which condition must be satisfied before an EIGRP neighbor can be considered a feasible successor?

Based on the need to limit processing and bandwidth utilization due to dynamic routing protocol operation, the following routing requirements have been specified for your network.
- partial and incremental routing updates
- only the devices affected by a topology change perform route recomputation
- route recomputation only occurs for routes that were affected Which dynamic routing protocol should be
deployed in your network to best meet these requirements?

Which statement about a non-zero value for the load metric (k2) for EIGRP is true?

Your network consists of a large hub-and-spoke Frame Relay network with a CIR of 56 kb/s for each spoke.
Which statement about the selection of a dynamic protocol is true?

When an EIGRP topology change is detected, what is the correct order of events when there is a FS?

Which BGP option is required when load sharing over multiple equal-bandwidth parallel links from a single CE router to a single ISP router over eBGP?

Which BGP feature should be used to avoid high memory utilization on a router?

Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6-only and IPv4-only nodes?

The administrator wants to verify the current state of the OSPF database loading process.
Which show command should the administrator use?

During the IPv6 autoconfiguration, what does the device append to the 64-bit prefix that it receives from the router to create its IPv6 address?