×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly, however, wireless clients are not obtaining correct access. You verify that the local switch
configuration connected to the access point appears as the following:
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem?
configuration connected to the access point appears as the following:
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem?
2.
Wireless has been operating correctly in the campus infrastructure. After the wireless controllers are upgraded from LWAPP to CAPWAP, access points no longer boot and operate normally. What is the most likely issue causing this problem?
3.
Which item is the most important factor during deployment of high-availability features?
4.
To initiate testing, which port does a Cisco IOS IP SLA source use to send a control message to an IP SLA responder?
5.
Which statement best describes Cisco supervisor engine redundancy using Stateful Switchover?
6.
You are tasked with designing a security solution for your network. What information should be gathered prior to designing the solution?
7.
You are tasked with designing a security solution for your network. What information should be gathered prior to designing the solution?
8.
You are tasked with designing a security solution for your network. What information should be gathered prior to designing the solution?
9.
What action should you be prepared to take when verifying a security solution?
10.
What is needed to verify that a newly implemented security solution is performing as expected?