Cisco Automating Cisco Collaboration Solutions CLAUTO

Which of the following is a function of the BAT?

You are troubleshooting voice audio problems on your company's VoIP network. The network carries both data and VoIP traffic. You have obtained the following measurements:

-Jitter: 50 ms
-Packet loss: 1 percent
-End-to-end delay: 150 ms
Which of the following best describes why your company's network is experiencing voice audio problems?

You want an IP phone to use a line prompt instead of an MWI lamp to display information about a new message.
Which of the following line appearance fields should you modify in UCM?

Which of the following QoS features reduces the jitter of voice packets by preventing them from being delayed behind larger data packets in a queue?

You have installed Cisco Unified Communications ELM. A warning message appears at the top of the interface.
Which of the following is most likely the problem?

You want Cisco Unified Serviceability to automatically notify you if the Cisco Tomcat service goes down.
Which of the following should you do?

You are manually configuring Cisco Jabber to connect to your company's UCM 8.6 deployment. You want to manually configure Jabber clients to connect to the following servers:
-TFTP: 192.168.51.10
-CTI: 192.168.51.9
-CCMCIP: 192.168.51.9
Which of the following should you do?

Which of the following can you display by clicking User Reports > Top N in the UCM 8.0 CAR GUI?

Which of the following enables an administrator to view reports and manage UCM features?

Which of the following best describes the purpose of the UCM DNA?