×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
The user tried to connect in SmartDashboard and did not work. You started a FWM debug and receive the logs below: What is the error cause?
2.
When troubleshooting and trying to understand which chain is causing a problem on the Security Gateway, you should use the command:
3.
Since switching your network to ISP redundancy you find that your outgoing static NAT connections are failing. You use the command _________ to debug the issue.
4.
Remote VPN clients can initiate connections with internal hosts, but internal hosts are unable to initiate connections with the remote VPN clients, even though the policy is configured to allow it. You think that this is caused by NAT. What command can you run to see if NAT is occurring on a packet?
5.
Where in a fw monitor output would you see source address translation occur in cases of automatic Hide NAT?
6.
Where in a fw monitor output would you see destination address translation occur in cases of inbound automatic static NAT?
7.
Which flag in the fw monitor command is used to print the position of the kernel chain?
8.
Server A is subject to automatically static NAT and also resides on a network which is subject to automatic Hide NAT. With regards to address translation what will happen when Server A initiates outbound communication?
9.
In your SecurePlatform configuration you need to set up a manual static NAT entry. After creating the proper NAT rule what step needs to be completed?
10.
Which FW-1 kernel flags should be used to properly debug and troubleshoot NAT issues?