×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
When configuring a new Ethernet Routing Switch (ERS) 8000 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is the ACLI interface obtained?
2.
Which CLI command is used to validate that synchronization for High Availability mode is set correctly?
3.
What does Ping snoop identify?
4.
Consider the following port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module:
Left LED green
Right LED flashing
What is the status of the port?
Left LED green
Right LED flashing
What is the status of the port?
5.
A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Ethernet Routing Switch (ERS) 8600-based core. The technician has to configure VRF on the ERS 8600. Which statement represents the order for configuring a new VRF?
6.
A technician is configuring an InterSwitch Frank (IST) for Spilt Multi-Link Franking (SMLT). Which statement about how the IST is addressed is true?
7.
What is the underlying dynamic link state routing protocol used for the implementation of the Avaya Enterprise Fabric?
8.
The Ethernet Routing Switch (ERS) 8600 switch includes a means to fine tune the memory resources by allowing the record allocations to be allowed. An ERS 8600 running Release 5.0 needs to be configured to be optimized for multicast traffic. Which command alters the ERS 8600 to increases the default allocation of Multicast by 50 percent?
9.
In a unified access solution that supports mobility, the configuration must allow for the creation of mobility tunnels to the remote switch and needs the reservation of a remote switch in mobility solution?
10.
In a multicast campus, when should an ERS 8600 PIM interface be configured to run in passive mode?