×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
A technician wants to use the New Unit Quick Configuration feature to add new units to a stack of Ethernet Routing Switch (ERS) 5000 switches without. As well as enabling the feature, what else must be done to use the New Unit Quick Communication feature?
2.
A technician is configuring 802.1 Q tagging, VLACP with short timeout, untagged frames to be discarded. Which part of the network is being configured?
3.
Where is the rate-limit feature of the Converged Campus architecture limited?
4.
Consider the following deployment requirements Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber. Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?
5.
During a power-on or cold-start sequence, at which stage can he flags to change the operational environment of the switch be set?
6.
Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a full stack of eight switches?
7.
Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green. What is the status of the port?
8.
A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast - Sparse Mode (PIM-SM) Which licensing requirement applies?
9.
An Ethernet routing switch (ERS) 4550T-PWR has been deployed with a single AC power supply and is currently supporting 20 VoIP telephones with power over Ethernet (PoE). each with a power draw of 8 Watts when offhook. The network engineer has requested the addition of 5 Wireless Access points (WAPs) to the ERS 4550T-PWR.Each WAP supports PoE and requires 12 Watts of power. What is the outcome of the addition of the WAPs to the ERS 455QT-PWR?
10.
A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches. Which statement about the correct uplink configuration is true?