Avaya ERS 8000 and Avaya VSP 9000 Implementation Set 2

After configuring your VSP 9000 for web access, engineers on the team says that they cannot log into EDM using their credentials. What are the default credentials for EDM?

During a power-on or cold-start sequence, at which stage can the flags to change the operational environment of the switch be set?

A customer is mirroring multiple ports to a single monitor port. What happens if the mirrored traffic exceeds the bandwidth of the monitor port?

A technician has implemented RSMLT edge design. After recovering from a power outage, some clients could not communicate. It has been determined that only one of the core RSMLT switches has recovered. What should have been done to prevent the loss of communications?

A customer has a edge switch connected to a cluster of VSP 9000 switches. The uplinks to the network core are via two Gigabit uplink ports. The uplinks are not aggregated and are running spanning tree protocol. The result is that one of the links is always being blocked, and recovery time is unacceptably long when the active uplink fails. They need to have both links active to increase the bandwidth to the core, and at the same time provide better redundancy. What is the preferred Avaya solution for the customer?

A customer is expressing concern about reliability for their single uplink connections to the wiring closet. The switches in the wiring closet support Distributed Multi-Link Trunking (DMLT). What can be done so the Virtual Services Platform (VSP) 9000 can eliminate a single point of failure for the lowest cost?

When troubleshooting an issue with an ERS 8000, running version 7.2, a technician notices that the "Online" LED is steady amber for longer than 3 minutes. This is an indication of a software incompatibility. What is the first step in resolving this issue?

Using Enterprise Device Manager, the technician opens the ERS 8000 switch and sees that there are five ports showing with an orange light. What does the orange light indicate?

While troubleshooting the VSP 9000 system, a technician notices that one port Link/Activity LED is blinking constantly or is nearly solid. This could be an indication of mis-configuration or high traffic volume. Using the CLI, what is the logical first step in troubleshooting this situation?

An engineer is configuring the VSP 9000 for EDM management, and cannot connect from the EDM computer to the VSP 9000. Once logged into the ACLI, which show command is used to see the status of the web server?