Avaya-Avaya Ethernet Routing Switch Implementation and Maintenance Exam 2 Set 3

A technician is configuring Multi Link trunking (SMLT) for an Ethernet routing switch (ERS) 8600 switch cluster. To ensure the fastest possible recovery time, which feature should be avoided?

A technician wants to use the New Unit Quick Configuration feature to add new units to a stack of Ethernet Routing Switch (ERS) 5000 switches without. As well as enabling the feature, what else must be done to use the New Unit Quick Communication feature?

A technician is configuring 802.1 Q tagging, VLACP with short timeout, untagged frames to be discarded. Which part of the network is being configured?

Where is the rate-limit feature of the Converged Campus architecture limited?

Consider the following deployment requirements Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber. Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?

During a power-on or cold-start sequence, at which stage can he flags to change the operational environment of the switch be set?

Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a full stack of eight switches?

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green. What is the status of the port?

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast - Sparse Mode (PIMSM) Which licensing requirement applies?

After checking the VLAN configuration using the show vlan info basic and the show vlan info port commands, there are no ACTIVE MEMBER ports for VLM4-50. What is causing this problem?