Avaya-Avaya Ethernet Routing Switch Implementation and Maintenance Exam 2 Set 2

A technician is setting up switch clustering using Split Multi-Link Trunking (SMLT). Which link is configured between the aggregation switches?

A technician is troubleshooting some IP telephones that are connected to an Ethernet Routing switch (ERS) 8300 8348TX-PWR I/O module. The IP telephones will not turn on. The 48V LED on the module has been checked and it is steady amber.

Which group of commands will configure Ethernet Routing Switch (ERS) 8600 to deny any source in the multicast group from reaching the multicast receivers connected to ERS 8600-B?

The Ethernet Routing Switch (ERS) 8600 switch includes a means to fine tune the memory resources by allowing the record allocations to be changed. An ERS 8600 running Release 5.0 needs to be configured to be optimized for multicast traffic. Which command alters the ERS 8600 to increase the default allocation of Multicast 50 percent?

A technician has implemented Routed Split Multi-Link Trunking (RSMI I) edge design. After recovering power outage some clients could not communicate. It has been determined that only one of the core RSMLT switches has recovered. What should have been done to prevent the loss communications?

While configuring packet capture Tool (PCAP), an Ethernet Routing Switch (ERS) 8600 switch has generated the following log: pcapAllocateBuffer: malloc(96 Mbs) failed Which event could have caused this log, and which course of action resolves the issue?

What does Ping snoop identify?

Routed Split Multi-Link Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN adding router redundancy. On which Ethernet Routing Switch (ERS) configuration component is RSMLT configured?

Which CLI command is used to validate that synchronization for high availability mode is set correctly?

A campus network has been established with four Ethernet Routing Switch (ERS) 8600 switches in a switch cluster, two pairs with an Inter Switch Trunks (1ST) running Split Multi-Link Trunk (SMLT) and Routed Split Multi-Link Trunking (RSMLT). The traffic filters are required to block specific source IP addresses to be forwarded through the core. How should these filters be set up?