1.
A CSPF LSP with no bandwidth requirement is established from Node 1 (10.10.1.1) to Node 2 (10.10.1.2).
OSPF-TE is enabled on all routers in the network. What commands can be used on Node 1 to determine if
another LSP can be established to Node 2 with 400M bandwidth requirement? Choose all that apply.

A. Show router lsp detail
B. Show router ospf database detail
C. Show router ospf opaque-database detail
D. Tools perform router mpls cspf to 10.10.1.2 bandwidth 400 E. Tools dump router mpls lspinfo
 
2.
Which one of the following CLI can be used to view all management VPLS configured on a 7x50?
A. Show service service-using m-vpls
B. Show service service-using
C. Show router vpls detail
D. Show service id base
E. There is no CLI command to display management VPLS
 
3.
Based on the configuration below, which statement best describes the reason why VPLS 101 is not up on all three nodes.
A. Service VC id has to match on all three nodes
B. SDP id has to match on all three nodes
C. STP has to be enabled on all three nodes
D. No SAP is configured on Node-2
E. Mesh-sdp has to be used on all three nodes
4.
Due to same VPLS mis-configuration, traffic (e.g.ping) is not work between PC1 and PC
2. Choose the best explanation for the problem.
A. MTU is not configured on all sdp
B. SDP id has to match on all three nodes
C. STP has to be enabled on all three nodes
D. No SAP is configured on Node-2
E. Spoke-sdp has to be used on all three nodes
5.
If a router needs to support services offering of 1514 byte service payload over POS with MPLS FRR, what is the physical MTU size required on the network ports?
6.
What are the possible logging destinations supported on the Alcatel 7x50?
7.
Which command is used to view alarms of all severity levels on the Alcatel 7x50?
8.
Which files have to exist on Compact Flash 3 during system initialization on the Alcatel 7x50?

 
9.
Which command should be used to enable automatic synchronization for all software images and configuration on the Alcatel 7x50?
10.
A policy is configured to redistribute four active static routes into ISIS. No ISIS route is received on the far end, what is the cause of the problem?